U-Boot for CM-FX6

From Compulab Mediawiki
Revision as of 17:02, 7 July 2014 by Nikita (talk | contribs)
Jump to: navigation, search

The CompuLab CM-FX6 module is using U-Boot boot-loader for low-level initializations and operating system loading. U-Boot is an open source firmware for wide range of embedded systems (e.g. PowerPC, ARM, MIPS, x86, ColdFire, AVR32, NIOS, etc.). On this page we will discuss only features and use cases related to CompuLab CM-FX6 module. For more information on U-Boot, please refer to Official U-Boot Homepage.

Cm-fx6-top.jpg


Resources
Evaluation
Development
Troubleshooting


News

07-Jul-2014
U-Boot 2014.04-cm-fx6-1.1 release:
- Improve SATA disks coverage
- Enable 3Gb/s SATA operation
01-Jul-2014
Added CM-FX6: U-Boot: Creating a bootable SD card article
30-Jun-2014
Initial release of U-Boot for CM-FX6
U-Boot 2014.04-cm-fx6-1 supports:
- MMC/SD Card
- SPI flash
- Ethernet
- NAND flash
- SATA and on-board SSD
- USB host and USB OTG in host mode
- Multiple I2C buses
- Green LED
- Fix NAND detection issue found in older U-Boot versions