Difference between revisions of "UCM-iMX8M-Plus: Evaluation Kit: Getting Started"
imported>Igor.vaisbein (Created page with "frameless|top|1400px|link= == System setup == UCM-iMX8M-Plus evaluation kit is preloaded with Yocto Linux image for UCM-iMX8...") |
|||
| Line 1: | Line 1: | ||
| − | [[Image:UCM- | + | [[Image:UCM-iMX8Plus-eval-kit-quick-setup.png|frameless|top|1600px|link=]] |
== System setup == | == System setup == | ||
| − | UCM- | + | UCM-iMX8Plus evaluation kit is preloaded with UCM-iMX8Plus Yocto Linux image. |
# Make sure jumpers '''E6''' and '''E9''' are populated (default state). | # Make sure jumpers '''E6''' and '''E9''' are populated (default state). | ||
# Make sure jumpers '''E20''' is removed (default state). | # Make sure jumpers '''E20''' is removed (default state). | ||
| − | # | + | # Optional - connect the LCD panel (if ordered with the kit) to connectors '''P11''' and '''P5'''. Ensure that the flat cables are fully inserted. |
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P13'''. | # Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P13'''. | ||
# On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings: | # On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings: | ||
Latest revision as of 13:47, 19 December 2023
System setup
UCM-iMX8Plus evaluation kit is preloaded with UCM-iMX8Plus Yocto Linux image.
- Make sure jumpers E6 and E9 are populated (default state).
- Make sure jumpers E20 is removed (default state).
- Optional - connect the LCD panel (if ordered with the kit) to connectors P11 and P5. Ensure that the flat cables are fully inserted.
- Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector P13.
- On your computer, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:
Baud Rate Data Bits Stop Bits Parity Flow Control 115200 8 1 none none
Starting the system
- Connect the DC 12V power supply adapter (included) to main DC power connector J2.
- Follow the messages in your terminal emulator program until you see the linux shell command line prompt.
|
In case of no messages appear in your terminal emulation program, please refer to the detailed USB console guide. |
