CM-T3530: Linux: Power management

From Compulab Mediawiki
Revision as of 08:38, 17 August 2010 by Mike (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Overview

The Linux kernel for CM-T3530 may be built with support for very low power sleep mode and dynamic frequency scaling.

Admolition important.png Use cm_t35_pm_defconfig kernel configuration file to build the Linux kernel with enabled power management features.

Frequency scaling

The Linux kernel for CM-T3530 utilizes cpu-freq framework for dynamic frequency scaling.

The CPU frequency can be changed on the fly using the following commands:

echo userspace > /sys/devices/system/cpu/cpu0/cpufreq/scaling_governor
echo <frequency> > /sys/devices/system/cpu/cpu0/cpufreq/scaling_setspeed

The frequency should be specified in MHz.

Suspend to RAM

The Linux kernel for CM-T3530 supports very low power sleep mode. Use the following commands to suspend the system:

mount -t debugfs debug /sys/kernel/debug/
echo <wakeup timeout> /sys/kernel/debug/pm_debug/wakeup_timer_seconds 
echo 1 > /sys/kernel/debug/pm_debug/enable_off_mode 
echo 1 > /sys/kernel/debug/pm_debug/voltage_off_while_idle 
echo disabled > /sys/devices/platform/serial8250/power/wakeup 
echo disabled > /sys/devices/platform/serial8250.0/power/wakeup 
echo disabled > /sys/devices/platform/serial8250.1/power/wakeup 
echo disabled > /sys/devices/platform/serial8250.2/power/wakeup 
echo mem > /sys/power/state

Limitations

  • The only wake-up source is the internal OMAP3 timer
  • The USB host driver should be compiled as loadable kernel module. It must be unloaded to allow the system enter the sleep mode.
  • The USB OTG driver should be excluded from the kernel
  • The video capture drivers should be excluded from the kernel

See also