CM-QS600: Android: Getting started

Overview

The following outlines the procedure necessary to install Android on CM-QS600.

Installation target media

CM-QS600 uses on-board eMMC as root file system medium.

Additional media might be enabled in the coming releases.

Installation onto eMMC

Preconditions

• CM-QS600 evaluation kit.
• PC workstation with installed fastboot client software.
• Connect HDMI display to the CM-QS600 (optional).
• Connect serial console to the CM-QS600 (optional).
• Connect USB cable between the CM-QS600 USB OTG (P7) jack and PC workstation, in order to enable fastboot protocol.

Flashing Android image

• Download prebuilt Android image.

• Decompress the file, in order to get Android partition images.

• Enter fastboot mode following either of the options:

1. There is no valid boot partition - this is the factory default in which the CM-QS600 comes out of the box.

   In this case, the device will enter fastboot mode upon power on.

2. There is a valid boot partition - usually the case when android was previously installed on the device.

   In this case, the device will boot from it.

   Accessing Android command line, one can observe and then destroy boot partition signature ("ANDROID"), effectively making boot partition invalid, going back to option 1 after reboot.

       # dd if=/dev/block/platform/msm_sdcc.1/by-name/boot bs=1 count=7
       # echo -n "X" | dd of=/dev/block/platform/msm_sdcc.1/by-name/boot bs=1 count=1

• Flash each partition image file to the eMMC with the aid of fastboot utility:

$ fastboot flash boot     boot.img
$ fastboot flash system   system.img
$ fastboot flash cache    cache.img
$ fastboot flash userdata userdata.img

• Proceed to boot, issuing

$ fastboot reboot

Boot

• Power on
• Within 3 seconds the device should start booting into Android.

Within 60 seconds the HDMI display should start showing signs of life.

See Also

• CM-QS600: Android: Serial console connection
• Android: Fastboot setup
• Android: ADB setup