Difference between revisions of "CM-QS600: Android: Operating instructions"
(→P9 100mil header) |
|||
Line 40: | Line 40: | ||
{{Note|If after making the selection with ''SoundAbout'' nothing happens, restart the application.}} | {{Note|If after making the selection with ''SoundAbout'' nothing happens, restart the application.}} | ||
− | === P9 | + | === P9 header === |
* SPI.0 | * SPI.0 | ||
: By default, SPI.0 is routed to the P9 header: | : By default, SPI.0 is routed to the P9 header: |
Revision as of 07:09, 22 March 2015
Contents
Overview
Most CM-QS600 supported features are operated using normal Android controls.
This page contains information about features and services, which are less straight-forward to operate, or are less widely known.
Operating instructions
Automatic suspend when inactive
By default, CM-QS600 is configured to stay awake while connected to the power.
In order to change this behavior, proceed to Settings->Developer options, uncheck Stay awake ... while charging to enable the device going to suspended state.
If Developer options item is hidden, re-introduce it proceeding to Settings->About tablet and clicking on Build number 7 times consequently. |
Start-up script
/system/etc/startup-svc.sh script is run upon system boot by Android init process with root permissions.
As system partition is mounted 'read-only', one should remount system 'rw', prior to attempting to edit the script.
Networking
Normal Android behavior is to prioritize network interfaces (in descend order):
- Ethernet
- Wi-Fi
- 3G
Whenever higher-priority network interface is available, the lower-priority interfaces will be torn down.
(Optional) 3G Modem
In case Telit HE910-XX 3G modem is installed, it will be detected automatically, by start-up service, with no additional action required.
Audio sink selection
CM-QS600 may use either HDMI or analog audio device. Audio sink selection should be done with a designated application, e.g. SoundAbout, available via Google Play Store.
audio device | sink name |
---|---|
HDMI | Aux Digital (HDMI) |
analog | Wired Headphones |
If after making the selection with SoundAbout nothing happens, restart the application. |
P9 header
- SPI.0
- By default, SPI.0 is routed to the P9 header:
- pin 1 : Clk
- pin 3 : nCS
- pin 5 : MOSI
- pin 7 : MISO
- UART (
/dev/ttyHSL1
)
- In order to override the default routing, the kernel should be rebuilt with patched CM-QS600 board file (
kernel/arch/arm/mach-msm/board-cm-qs600.c
):
- #define CM_QS600_GSBI4_AS_SPI + // #define CM_QS600_GSBI4_AS_SPI
UART routing to the P9 header:
- pin 5 : TX
- pin 7 : RX