Igor: Created page with "NOTOC link= == System setup == UCM-iMX91L evaluation kit is preloaded with the UCM-iMX91L Yocto Linux i..."

2025-04-06T13:36:54Z

Created page with "__NOTOC__ frameless|top|1040px|link= == System setup == UCM-iMX91L evaluation kit is preloaded with the UCM-iMX91L Yocto Linux i..."

New page

__NOTOC__
[[Image:UCM-iMX91L-eval-kit-quick-setup.png|frameless|top|1040px|link=]]

== System setup ==
UCM-iMX91L evaluation kit is preloaded with the UCM-iMX91L Yocto Linux image.
# Make sure jumper '''E5''' is populated (default state).
# Make sure jumpers '''E3''' and '''E4''' are not populated (default state).
# Make sure that main power switch '''SW1''' is in the '''OFF''' position.
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit console connector '''P3'''.
# On your computer, start a terminal emulation program (such as [https://www.putty.org/ PuTTY] on Windows or minicom on Linux) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included) to main DC power jack '''J1'''.
# Toggle the main power switch '''SW1''' to '''ON''' position.
# Follow the messages in your terminal emulator program until you see the linux shell command line prompt.
{{note|In case no messages appear in your terminal emulation program, please refer to the detailed [[SB-UCM-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What's Next? ==
* [https://www.compulab.com/products/computer-on-modules/ucm-imx91l-nxp-i-mx-91-som-system-on-module/#devres UCM-iMX91L development resources]

[[Category:UCM-iMX91L]]

UCM-iMX91L: Evaluation Kit: Getting Started - Revision history

Igor: Created page with "__NOTOC__ link= == System setup == UCM-iMX91L evaluation kit is preloaded with the UCM-iMX91L Yocto Linux i..."

Igor: Created page with "NOTOC link= == System setup == UCM-iMX91L evaluation kit is preloaded with the UCM-iMX91L Yocto Linux i..."