Mike at 14:56, 15 March 2010

2010-03-15T14:56:07Z

New page

== Image Installation ==
In order to install Windows CE 6.0 CompuLab demo image perform the following steps:
* Download Windows CE run-time image package from [http://www.compulab.co.il/x270em/download/x270-em-wince6-img.zip CompuLab website]
* Copy the contents of LiveDisk directory from this package to a USB flash drive.
* Insert the USB flash drive into “USB-A to mini-USB” adapter supplied with the EM-X270 evaluation kit, and connect the other side of the adapter to the EM-X270 card.
* Power up the EM-X270 while holding down the suspend/resume button for a few seconds. A good indication of the proper installation process start can be the blinking of USB flash drive activity led.
* An Updater image (dedicated Windows CE image) is loaded from the USB flash drive. Updater image boot time is approximately 50 seconds.
* The Updater utility will start automatically. The utility will install the run-time image onto the EM-X270 NAND flash (approximately 2 minutes).
:[[Image:CM_T35_Updater_Running.jpg|320px]]
* The Updater utility will automatically reboot the EM-X270 upon successful completion.
* CompuLab Windows CE demo image will be loaded from the NAND flash.
:[[Image:EM_X270_Updater_Finished.jpg|320px]]

== Installation Troubleshooting ==
If you experience any problem during the installation read the [[EM-X270: WinCE: Installation Troubleshooting | Installation Troubleshooting]] section.

== See also ==
*[[EM-X270: WinCE: Installation Troubleshooting | EM-X270 Installation Troubleshooting]]<br>
*[[EM-X270: WinCE: Demo Image | EM-X270 Using Demo Image]]
*[[EM-X270:_WinCE:_Console_Setup | EM-X270 Serial Console Setup]]

[[Category:Windows CE|Getting Started]]
[[Category:EM-X270|WinCE: Getting Started]]

EM-X270: WinCE: Getting Started - Revision history

Mike at 14:56, 15 March 2010