Nadav at 10:08, 23 December 2009

2009-12-23T10:08:38Z

New page

__NOTOC__

* Connect the host PC to the SB-T35 base-board (connector P12) via the serial cable supplied with the evaluation kit. If the host PC does not have a serial port, a USB to serial adapter can be used.
* Start terminal emulation software on the host PC. Set baud rate to 115200 bps, 8 bit per frame, 1 stop bit, no parity, no flow control.
{{Note | Windows Hyper Terminal may be used as terminal emulation program. However, it is recommended to use a more advanced terminal such as [http://www.tucows.com/preview/503076 IVT VT220].}}

== IVT VT220 Configuration ==
* Launch IVT VT220.
* In transport protocol, choose "Serial" with the following settings:
** Portname: Com''X'' (''X'' is the serial port number used. The port number can be found in Windows Device Manager in the "ports" section).
** Baud rate: 115200
** Parity: None
** Data bits: 8
** Stop bits: 1 [[Image:CM_T35_IVT_Create_Session_Window.jpg.jpg]] 
* Press the "Setup" button.
* The "IVT Setup System" window opens. Press the serial settings button. [[Image:CM_T35_IVT_Setup_System_Window.jpg]] 
* In the Serial Setup window, choose the following settings: [[Image:CM_T35_IVT_Serial_Setup_Window.jpg]] 
* Save the settings.

[[Category:CM-T3530|WinCE: Console Setup]]
[[Category:Windows CE|Console Setup]]

CM-T3530: WinCE: Console Setup - Revision history

Nadav at 10:08, 23 December 2009