imported>Igor.vaisbein: /* System setup */

2019-07-30T14:13:17Z

‎System setup

New page

[[Image:SOM-iMX8X-evaluation-kit-quick-setup.jpg|frameless|top|800px]]
== System setup ==
CL-SOM-iMX8X evaluation kit is preloaded with the [[CL-SOM-iMX8X NXP i.MX 8X Yocto Linux|CL-SOM-iMX8X Yocto Linux image]].
# Connect a DVI/HDMI Display to HDMI connector '''J1''' using a standard HDMI/DVI cable.
# Connect a USB Keyboard to USB connector '''U30'''.
# Make sure jumper '''E15''' is not populated.
# Make sure jumpers '''E8''', '''E9''' and '''E10''' are populated (default state).
# Connect a standard USB cable (included in the kit) between your host PC and the evaluation kit micro-USB2.0 connector '''P12'''.
# On your host PC, start a terminal emulation program (such as HyperTerminal) with the following serial port settings:
<blockquote>
{{:SB-SOM: serial port parameters table}}
</blockquote>

== Starting the system ==
# Connect the DC 12V power supply adapter (included in the kit) to DC power connector '''J3'''.
# Follow the messages in your terminal emulator program until you see the linux login prompt.
# Use the credentials below to login.
:* username: root
:* no password
{{note|In case no messages appear in your terminal emulation program, please refer to the detailed [[SB-iMX8: HOWTO: USB Console|USB console]] guide.}}

== What Next? ==
* [https://www.compulab.com/products/computer-on-modules/cl-som-imx8x-nxp-i-mx-8x-system-on-module-computer/#devres CL-SOM-iMX8X development resources]

[[Category:SB-iMX8X]]
[[Category:CL-SOM-iMX8X]]

CL-SOM-iMX8X: Evaluation Kit: Getting Started - Revision history

imported>Igor.vaisbein: /* System setup */